Typing any command into the IDE editor causes a problem not showing in the IDE table view

[noahhath]

This references to the issue describes here and I found out it applies to any command selections

Typing "Pause" command into the editor causes a problem

When I create a new line in my macro and select pause the field stays empty unless I save the macro and select it again: [image] [image]

Open IDE in side bar
From there open IDE in window
Insert a new line in the code “Empty” Line [Insert new Line]
In Command type “Pause” and DO NOT ENTER
Click into the “Target” or “Value” Field
→ Command blanks out

And I also confirm that this was working with version 8.3.9 not not with the new version that supports side bar.

[kevin458]

If you need help with the AZMVDNow process or want to get on-call assistance by dialing the AZMVDNow phone number, then this page is for you; it has clear step-by-step instructions and essential contact information. NJMVC